Mechanical Assembler 1St Shift

What you’ll do:

• You will set up and operate small lathes, automatic machines, drill presses, lapping machines, pneumatic drill presses, hydraulic presses and marking. Perform hydraulic tests on parts and assemblies as specified on methods and verbal instructions in K Department.
• You will perform a variety of secondary machining operations such as turning, boring, chamfering, counterboring, and general assembly work. Prepare, sandblast components, and run spot welding machine. Setup by others.
• You will use micrometers, Vernier’s, vacuum check, monochromatic light, optical flat, stops and guides, plug gages, expansion plugs and indicators. Set speeds and feeds, tools, depth gauges, comparators, and similar instruments.
• You will machine fixtures, jaws, plugs, and similar parts. Change and reset dull tooling as required. Charge table plates with diamond paste following prescribed methods. Repair parts and finished seals as instructed or directed by Supervisor
• You will work from prints, method sheets, operation sheets, specification sheets, sketches, and/or verbal instructions to produce parts in accordance with acceptable quality and quantity levels.
• You will be responsible for checking own work after first piece check by Supervisor.
• You will report faulty operation, defective material, and unusual conditions to Supervisor.

Qualifications:

Basic Qualifications:

• This position requires use of information or access to hardware which is subject to the International Traffic in Arms Regulations (ITAR). All applicants must be U.S. persons within the meaning of ITAR. ITAR defines a U.S. person as a U.S. Citizen, U.S. Permanent Resident (i.e., 'Green Card Holder'), Political Asylee, or Refugee.
• No relocation benefit is being offered for this position. Only candidates within a 50-mile radius of Rumford, RI will be considered. Active-Duty Military Service member candidates are exempt from the geographical area limitation.
• Minimum of High School Diploma or GED from an accredited institution
• Must be able to work in the United States without corporate sponsorship now and in the future

Preferred Qualifications:

• Knowledgeable in GD&T
• Experience with precision measurement instrumentation
• Ability to read and interpret complicated drawings, specifications, charts, tables

#IND123

#LI-RR2